Automatic Capacitor Banks
Description
LIFASA automatic capacitor banks are used for centralized compensation of power factor in low voltage installations.
These equipments are supplied completely assembled and ready for use: it is only necessary to connect it to the mains with cables of adequate cross section, and to supply the
operation signal from a suitable current transformer.

General CharaCteristiCs
LIFASA automatic capacitor banks are composed of the following elements:
High rupturing capacity (HRC) fuses connected to a busbar system.
Contactors specially adapted to the work with capacitors.
Inrush current limiting inductances.
Fast discharge resistors.
Low losses power capacitors.
Reactive power controllers.
Terminals for neutral and ground conductors.
Metal cabinet containing all the switchgear.

Advantages
Equipments wired and tested at works, full finished and supplied with all control and safety devices.
Easy transportation and installation due to their light weigh.
Easy selection of the most appropriate cos ¦Õ to avoid penalty charges on tariffs.
Long life and high reliability, thank to the use of selfhealing and low losses capacitors.
Wide range of power (from 5 to 1600 kvar, 440 V) with standard equipments for immediate delivery.
Option of including various accessories.

Technical characteristics

SpeCial equipMent
On request, automatic capacitor banks can be produced to customers special requirements. Among the different possibilities are the following:
Other voltages and frequencies.
Capacitor banks with different degrees of protection.
Capacitor banks for outdoor installation.
Working program 1:2:4:4:, 1:2:4:8:,1:1:2:2:.
Fixed step (for transformer compensation).
Higher powers than the above stated.

BATM 5-180 kvar WALL MOUNTED AUTOMATIC CAPACITOR BANK

DesCription

LIFASA automatic capacitor banks are used for centralized compensation of power factor in low voltage instalations.
These equipments are supplied completely assembled and ready for use: it is only necessary to connect it to the mains with cables of adequate cross section, and to supply the operation signal from suitable current transformer. Wall mounting equipment. POLIMET capacitors.

TeChniCal CharaCteristiCs

Tensi¨®n nominal/Rated voltages......................440 V 50 Hz - 60 Hz
Regulador/Controller ........................................MCE ADV
Programa de trabajo/Working program .........5 opciones
5 options
Condensadores/Capacitors .............................POLB 440 V
Protecci¨®n/Protecci¨®n steps .............................Magnetot¨¦rmico / MCB
Grado protecci¨®n/Degree of protection ......
Color/Colour .......................................................RAL 7035
Entrada cables/Cables entry ..........................Inferior/bottom
Instalaci¨®n/Installation ......................................Interior/Indoor
Montaje/Assembly .............................................Mural/Wall mounting
Tensi¨®n aux. 230V/Aux. voltage 230V .......Autotrafo/ Autotransformer
Interruptor autom./Circuit breaker .................Hasta/Up Qn=40 kvar (...I)
TI externo/External TI ....................................... .../5A (no incl./not included)
a ccesorios /a CCessories
Interruptor general autom¨¢tico o de corte en carga...............Qn>40kvar/440V
Main switch or circuit breaker H¡Ý700mm
Protecci¨®n diferencial / Leakage protection

Other ratings, voltages and frequencies available on request.